Once we’ve run our wire and set and enabled the gas, it’s time to try our hand at the first weld. Ben walks you through the initial steps of a weld, teaching you in practice to do the following:
- Adjusting the controls
- Running a weld
- Troubleshooting
You Might Also Enjoy...
-
6:56Classic Electrics – Principles Explained and Applied
In the first step of our five-part course, Ed Hughes teaches you the basics of electricity and how these basics apply to the wiring on your classic car. You’ll learn some of the key terms that will come in handy later in this series, including the essential technology that connects your car’s electrical components to the car’s battery.
Watch Now >> -
1:44Classic Electrics Introduction – the Can-do Guide
As with most projects in the garage, it’s important to first learn the essential techniques and then challenge yourself on the more complicated scenarios. To help you gain an introductory understanding of classic car electrics, Danny Hopkins and Ed Hughes are here to demonstrate a number of simple car maintenance projects that focus on classic car electrics. With each of the five classes in this course, you’ll discover a new technique that you can implement in your own garage and grow more confident as a classic car restorer.
Watch Now >> -
9:17Circuit Diagrams Explained – Faultfinding Guide
More often than not, an electrical issue on a classic car is as simple as adjusting a fuse or correcting a faulty wire. For those times when it’s just a bit more complicated, Ed teaches you how to read a circuit diagram on your classic car to discover where the faulty component might be in your car’s system.
Watch Now >> -
10:02How to Install Auxiliary Lights – Step by Step Guide
Now that you know how to join two wires and you have a basic understanding of circuit diagrams, it’s time to try your hand at a simple project. Learn how to use essential tools and your new knowledge of electrical wiring to install auxiliary lights to the front of your classic car.
Watch Now >>