When tightening and untightening cylinder head nuts, work out from the centre in a spiral to ensure minimal stress is put on the cylinder head.
You Might Also Enjoy...
-
19:30MIG Welding Masterclass: Welding a Patch Repair
Taking care of a rotten part on your car can be challenging, but fixing the problem before it spreads is highly important for the overall integrity of the body. Michael Coman helps you through the often difficult process of removing a corroded section from a car’s frame and welding a simple patch to fill the gap and restore the strength of your vehicle.
Watch Now >> -
9:17Circuit Diagrams Explained – Faultfinding Guide
More often than not, an electrical issue on a classic car is as simple as adjusting a fuse or correcting a faulty wire. For those times when it’s just a bit more complicated, Ed teaches you how to read a circuit diagram on your classic car to discover where the faulty component might be in your car’s system.
Watch Now >> -
12:44Timing the Ignition and Replacing and Gapping Points
In this class, Ed teaches you four new techniques pertaining to ignition maintenance for an engine’s distributor on a classic car, including:
Setting and changing contact breakers
Watch Now >>
Making sure a condenser is working properly
Timing the ignition -
6:47How to Get the Best Finish After Welding
Michael Coman demonstrates the proper technique for achieving a sleek, even finish on a weld. You’ll learn about necessary safety equipment and the correct protocol for using various grinding and sanding tools to carefully wear down the weld until it is flush with the surfaces of your newly joined pieces.
Watch Now >>