Vacuum and pressure bleeders explained. Ed takes you through the methodology and gives you top tips for a successful bleed.
You Might Also Enjoy...
-
6:47Michael Coman demonstrates the proper technique for achieving a sleek, even finish on a weld. You’ll learn about necessary safety equipment and the correct protocol for using various grinding and sanding tools to carefully wear down the weld until it is flush with the surfaces of your newly joined pieces.
Watch Now >> -
7:46In the final class of our course on classic car electrics, Ed teaches you about the ignition system on your car. He discusses the two halves of the ignition system, explains how the system is wired to the rest of a car, and then shows you how to trace faults.
Watch Now >> -
24:27In the final step of the engine decoking process, you’ll learn to reassemble the head, replace a new gasket, and remount the cleaned and decoked components onto the engine block. Ed walks you step by step through the finishing methods needed to put the cylinder head back together and make sure everything is properly affixed and operational.
Watch Now >> -
18:26In the previous class, Ed showed you how to clean the valves and prepare them for reinsertion into the head. Now, you’ll learn how to lap in the valves using grinding paste and then decoke the engine in order to increase its efficiency and ensure top-notch engine performance for another several thousand miles. Ed introduces the tools you need to complete this process and then shows you how to use them.
Watch Now >>