• 7:46

    In the final class of our course on classic car electrics, Ed teaches you about the ignition system on your car. He discusses the two halves of the ignition system, explains how the system is wired to the rest of a car, and then shows you how to trace faults.

    Watch Now >>
  • 10:02

    Now that you know how to join two wires and you have a basic understanding of circuit diagrams, it’s time to try your hand at a simple project. Learn how to use essential tools and your new knowledge of electrical wiring to install auxiliary lights to the front of your classic car.

    Watch Now >>
  • 9:17

    More often than not, an electrical issue on a classic car is as simple as adjusting a fuse or correcting a faulty wire. For those times when it’s just a bit more complicated, Ed teaches you how to read a circuit diagram on your classic car to discover where the faulty component might be in your car’s system.

    Watch Now >>
  • 10:48

    Discover the basic set of tools you’ll need to complete a number of electrical jobs on your classic car. Ed Hughes introduces these necessary tools and then demonstrates the quick methods he uses to join two wires.

    Watch Now >>
  • 6:56

    In the first step of our five-part course, Ed Hughes teaches you the basics of electricity and how these basics apply to the wiring on your classic car. You’ll learn some of the key terms that will come in handy later in this series, including the essential technology that connects your car’s electrical components to the car’s battery.

    Watch Now >>
  • 1:44

    As with most projects in the garage, it’s important to first learn the essential techniques and then challenge yourself on the more complicated scenarios. To help you gain an introductory understanding of classic car electrics, Danny Hopkins and Ed Hughes are here to demonstrate a number of simple car maintenance projects that focus on classic car electrics. With each of the five classes in this course, you’ll discover a new technique that you can implement in your own garage and grow more confident as a classic car restorer.

    Watch Now >>
  • 24:27

    In the final step of the engine decoking process, you’ll learn to reassemble the head, replace a new gasket, and remount the cleaned and decoked components onto the engine block. Ed walks you step by step through the finishing methods needed to put the cylinder head back together and make sure everything is properly affixed and operational.

    Watch Now >>
  • 18:26

    In the previous class, Ed showed you how to clean the valves and prepare them for reinsertion into the head. Now, you’ll learn how to lap in the valves using grinding paste and then decoke the engine in order to increase its efficiency and ensure top-notch engine performance for another several thousand miles. Ed introduces the tools you need to complete this process and then shows you how to use them.

    Watch Now >>
  • 25:27

    Once you’ve removed the cylinder head from the engine block, it’s necessary to dismantle the head to properly assess its condition and decide the next course of action. Ed teaches you how to search for any damage on the surface, including to the valves, head and copper sealing rings and the head gaskets, and then takes the head apart to have a look at each of the components inside.

    Watch Now >>